Honeywell MAXPRO MPIP2000U Series User Manual

7.3.3 Determining the Size of the Standby Battery 116
7.3.4 Battery Installation 117
7.4 Connecting to MAXPRO Cloud 119
7.4.1 Workflow 119
7.4.2 Troubleshooting 121
7.4.3 Using Manual Mode on the Keypad 121
7.5 Shutting Down the Panel Securely 122
8 Configuration in MAXPRO Cloud 124
8.1 MAXPRO Cloud User Interface 124
8.2 Site Settings 125
8.2.1 Overview Tab 125
8.2.2 Settings Tab 125
8.3 Control Panel Settings 125
8.3.1 Overview Tab 125
8.3.2 About Installer Mode 126
8.3.3 Settings Tab 127
8.3.4 Communication Path Tab 127
8.3.5 Alarm Signalling Tab 128
8.3.6 AlarmNet Settings 128
8.3.7 Diagnostics Tab 129
8.4 Device Status 129
8.5 Control Panel Input/Output Settings 129
8.5.1 Zones Tab 129
8.5.2 Outputs Tab 129
8.5.3 Diagnostics Tab 130
8.6 Keypad Settings 130
8.7 Door Control Module Settings 130
8.7.1 Overview Tab 130
8.7.2 Settings Tab 130
8.7.3 I/O Tab 131
8.8 Relay Module Settings 131
8.8.1 Settings Tab 131
8.8.2 Outputs Tab 131
8.9 Remote Power Supply Settings 131
8.9.1 Settings Tab 131
8.9.2 Outputs Tab 132
8.9.3 Diagnostics Tab 132
8.10 Zone Expander Settings 132
8.10.1 Settings Tab 132
8.10.2 Zones Tab 132
8.10.3 Outputs Tab 133
8.11 V-Plex devices 133
8.12 Areas 133
8.12.1 Settings Tab 133
8.12.2 Sensors Tab 133
8.12.3 Outputs Tab 133
8 800-23044 Rev. A draft_11
Installation and Setup Guide Honeywell MAXPRO Intrusion MPIP2000U/3000U Series

Honeywell MAXPRO MPIP2000U Series Specifications

General

Brand	Honeywell
Model	MAXPRO MPIP2000U Series
Category	Security System
Language	English