Honeywell Notifier AM12-24 - First file (Enable of a zone test function); Second file (Output selection)

PAGINA - 34 Installation and programming manual AM-1224
NOTIFIER ITALIA Doc. M-124.1-AM1224-ENG Rev A.1 AM-1224_manu


F
F
i
i
r
r
s
s
t
t
f
f
i
i
l
l
e
e
(
(
E
E
n
n
a
a
b
b
l
l
e
e
o
o
f
f
a
a
z
z
o
o
n
n
e
e
t
t
e
e
s
s
t
t
f
f
u
u
n
n
c
c
t
t
i
i
o
o
n
n
)
)
To change one or more data in this file, select parameter with arrow keys (characters of the selected item
are in reverse), press enter key
and use arrow keys to modify the parameter. Finally press enter key
to save the configuration.


S
S
e
e
c
c
o
o
n
n
d
d
f
f
i
i
l
l
e
e
(
(
O
O
u
u
t
t
p
p
u
u
t
t
s
s
e
e
l
l
e
e
c
c
t
t
i
i
o
o
n
n
)
)
In the next programming folder is possible to select the output to be activated in case of alarm by a line in the
test area.
To change one or more data in this file, select parameter with arrow keys (characters of the selected item
are in reverse), press enter key
and use arrow keys to modify the parameter. Finally press enter key
to save the configuration.
 LED: By selecting with arrow keys  LED item and connfirming with enter key , the control panel
perform the lamp-test (blinking for a few seconds all control panel LEDs).
 LCD: By selecting with arrow keys  LED item and connfirming with enter key , the control panel
perform the test of display.
Enable CBE
Select CBE active: YES
In case of alarm from devices in the test zone, CBE
equation associated will be activated.
In the “Select.” Field is possible to select one of following item:
NONE = in caso di allarme dalla zona in test non attiva uscite.
SOUNDER = for every alarm event in the test area will be activated the
sounder output 3 sec.
Output addr. = or every alarm event in the test area will be activated the
configured output 3 sec.
Enter the zone number (from 1 to 24) for which
you want to activate the test function.
(00 = test function not activated)