Honeywell SmartLine ST 800 - Page 37

27 ST 800 Pressure Transmitter User’s Manual Revision 15
Non-Critical
(continued)
PILD Block OS
(Optional)
OK
BLOCKED
It is applicable for DP transmitter only.
OK: Blockage is not detected. BLOCKED:
Blockage is detected at one side of impulse
line.
See Note below this table.
PILD Block BS
(Optional)
OK
BLOCKED
It is applicable for DP transmitter only.
OK: Blockage is not detected. BLOCKED:
Blockage is detected at Both sides of
impulse line.
See Note below this table.
PILD Blockage
(Optional)
OK
BLOCKED
It is applicable for AP/GP transmitter only.
OK: Blockage is not detected. BLOCKED:
Blockage is detected at measurement side.
See Note below this table.
PILD (Optional)
<Return>
Current Mode
Training
Monitoring
Displays the current status of PILD
algorithm i.e., either Training mode or
Monitoring Mode.
See Note below this table
PILD Factor
PILD factor for
blockage prediction
0.0 to 1.0
Displays the current PILD factor value. See
the Note below in table.
Training Result
SUCCESS
FAILED
Displays the training mode result.
NOTE: This diagnostics message or PILD sub menu will be visible only if PILD feature is supported by the sensor
and user enabled in the PILD option in the transmitter.