Honeywell SmartLine ST 800 - Table 11 - Display Setup Menus

28 ST 800 Pressure Transmitter User’s Manual Revision 15
Table 11 – Display Setup Menus
<Return> Return to the Level 1 menu
LCD
Contrast
<Return>
Set
Contrast
# #
Adjust the LCD contrast level. Range
from 0 to 9.
Default: 5
Press  to enter menu
selection
 and  to select
number.
 to enter and shift to
next digit
Common
Setup
<Return>
Set
Password
####
Enter the display configuration
password. Default: 0000.
This value disables the password.
All other values enable the password.
When enabled, a prompt to enter the
password is presented only on the
first parameter successfully accessed
to change after entering the menu.
Language
• English, French,
German, Italian,
Spanish, Russian
& Turkish
• English, Chinese,
Japanese
Select the language for the Display.
Default: English
Press  to enter menu
selection
 and  to select from
list.
 to enter
Rotation
Time
# #
Time duration, in seconds, that
each configured screen is shown
before moving to the next screen.
Range: 3 to 30 seconds
Default: 10 seconds
Press  to enter menu
selection
 and  to select
number.
 to enter and shift to
next digit
Units
atm
bar
ftH2O @ 68F
gf/cm2
inH2O @ 39F
inH2O @ 60F
inH2O @ 68F
inHg @ 0C
kgf/cm2
kPa
mbar
mmH2O @ 4C
mmH2O @ 68F
cmH2O @ 4C
mH2O @ 4C
mmHg @ 0C MPa
Pa
psi
Torr
This selection determines the units of
the values shown on the following
menu items:
• Enter LRV
• Enter URV
• Set LRV
• Set URV
• Zero Correct (Calib. menu)
• LRV Correct (Calib. menu)
• URV Correct (Calib. menu)
• Calibration Parameters
(Calib. menu)
• Cal Low Correct (Calib.
menu)
• Cal High Correct (Calib.
menu)
• Barometric Correct (Calib.
menu)
• LRL (Meter Body Info.
menu)
• URL (Meter Body Info.
menu)
Press  to enter menu
selection
 and  to select from
list
 to enter