Honeywell SmartLine ST 800 - Page 39

29 ST 800 Pressure Transmitter User’s Manual Revision 15
For calibration, this parameter
allows the user to match the value
displayed on the menus to the units
supported by the user’s
calibration equipment.
Screens
1 thru 8
<Return>
Screen
Format
None
Select the Screen format from the
list.
Press  to enter menu
selection
 and  to select from
list.
 to enter
PV
PV & Bar Graph
PV & Trend
Trend
Duration
##
Select the amount of historic data
visible on the Trend screen. Range:
1 to 24 hours.
Applies to the “PV & Trend”
format only
Press  to enter menu
selection
 and  to select
number.
 to enter and shift to
next digit
PV
Selection
DP, AP, or GP
Pressure
Select the Process Variable
(PV) that will be shown this
screen.
Press  to enter menu
selection
 and  to select from
list.
 to enter
Meter Body Temp
Loop Output
Percent Output
Static Press
PILD Factor
(Optional)
See Note 3 below
PV
Scaling
None
Display the PV in the default
units associated with the PV
Selection. Default units:
• Pressure: inH2O @ 39ºF
• Meter Body Temp: ºC
• Loop Output: mA
• Percent Output: %
• Static Pressure: psi
Press  to enter menu
selection
 and  to select from
list.
 to enter
Custom Units:
 and  to select
Alphanumeric
 to enter and shift to
next char
Convert Units
(Default PV scaling
selection)
Convert the displayed PV to any
pressure unit listed under
Display Units
Linear
See Note 1 below
Display
Units
Custom
up to 8
characters
Square Root (only
available for DP
transmitters)
See Note 2 below.
Display
Units
%
Custom
Units
up to 8
characters
gal/min
gal/h
impgal/h
L/s
L/min
L/h
bbl/h
CFH
SCFM