Honeywell SmartLine ST 800 - Table 16 - ST 800 Standard Transmitter: Standard Display Menus Russian Language

58 ST 800 Pressure Transmitter User’s Manual Revision 15
Screen4 Pressure
Scaling High
[70PSCLHI]
########
When “Custom” selected for
Screen4 Pressure Units, enter the
Screen4 Pressure Scaling High
value.
Value of the pressure custom
engineering unit corresponding to the
URV of the transmitter
The limits are:
-999999 to 999999
Press  to
enter menu
selection
 Menu to
select
number.
 to enter and
shift to the
next digit to
the right
Extended Menu
[EXDMNU]
DISABLE
ENABLE
Select ‘Enable’ to enter ‘EX MENU’
and ‘Disable‘ to enter into ‘SD
MENU’
Press  to
enter menu
selection
Menu to
select from
list
 to enter
[EXIT]
Exit
Exit from Menu
Exit from
Menu list
 to enter
Table 16 - ST 800 Standard Transmitter: Standard Display Menus Russian Language
Menu
Submenu/Selection/ Value
Entry
Description
Action
1Ед.Изм
[1UNITS]
aтм (atm)
Бар (bar)
ftH2O68F
гс/см2 (gf/cm2)
inH2O39F
inH2O60F
inH2O68F
inHg0C
кгс/см2 (kgf/cm2)
кПа (kPa)
мБар (mbar)
ммH2O4C (mmH2O4C)
ммH2O68F (mmH2O68F)
mmHg0C (ммHg0C)
МПа (MPa)
Па (Pa) пси
(psi) торр
(Torr)
мH2O4С (mH2O4C)
смH2O4C (cmH2O4C)
Choose appropriate
engineering units from list
This selection determines the
units of the values shown on
the following menu items:
• Enter LRV
• Enter URV
• Set LRV
• Set URV
• Zero Correct
• LRV Correct
• URV Correct
• Cal Low Point
• Cal High Point
• Cal Low Correct
• Cal High Correct
• Barometric Correct
For calibration, this parameter
allows the user to match the
value displayed on the menus
to the units
supported by the user’s
calibration equipment.
Press  to
enter menu
selection
Menu to
select from
list
 to enter