40 ST 800 Pressure Transmitter User’s Manual Revision 15
Table 14 – Information Menus
<Return> Return to the Level 1 menu
The firmware version of the Display module
The firmware version of the Electronics Module
The firmware version number of the Electronics Module as
displayed via the HART and DE protocols
The communications protocol of the transmitter:
•
HART: HART protocol
•
DE: Honeywell DE protocol
•
FF: Foundation Fieldbus
The firmware version of the Meter body
Identifies the type and range of the transmitter
The Engineering Units for the LRL and URL. Note
that you can change these Units from the transmitter
Setup menu, if desired (transmitter
Setup\Parameters\Units)
The Lower Range Limit of the Meter Body
The Upper Range Limit of the Meter Body
Unique serial number of the transmitter
########
License key to enable PILD option
Write
only
(enter
numeric
license
key
4.2.6 The Standard Display Menu
The Standard Display Menu is implemented as one long single level and will “wrap around” when
scrolling past the end of the menu. Operation is as follows:
Press the button to call up the Menu.
1. Select <Exit Menu> and press to exit the Menu.
2. Use the Menu button to scroll through the list of menu items.
3. Press the button to select an item for data entry or activation. When an item is selected for data
entry or activation, the cursor will jump to the lower line of the LCD to allow editing of the value.
No action is taken against a menu item until the user presses the button.
To Next Page
Loading...
