Honeywell SmartLine ST 800 - Table 15 - the Standard Display Menus

41 ST 800 Pressure Transmitter User’s Manual Revision 15
4. If you want to abort a data entry operation, simply refrain from pushing any buttons for 10
seconds; the data entry operation will time out and the original value of the selected item will be
preserved.
Table 15 – The Standard Display Menus
Pressure Units [
1UNITS]
atm
bar
ftH2O68F
gf/cm2
inH2O39F
inH2O60F
inH2O68F
inHg0C
kgf/cm2
kPa
mbar
mmH2O4C
mmH2O68F
mmHg0C
MPa
Pa
psi
Torr
mH2O4C
cmH2O4C
Choose appropriate engineering
units from list for calibration and
writing LRV/URV
This selection determines the units
of the values shown on the following
menu items:
• Enter LRV
• Enter URV
• Set LRV
• Set URV
• Zero Correct
• LRV Correct
• URV Correct
• Cal Low Point
• Cal High Point
• Cal Low Correct
• Cal High Correct
• Barometric Correct
For calibration, this parameter
allows the user to match the value
displayed on the menus to
the units supported by the user’s
calibration equipment.
Press  to
enter menu
selection
Menu to
select from
list
 to enter
Enter LRV
[ 2ENTLRV]
Enter URV
[ 3ENTURV]
###. ##
###. ##
The limits are:
2X the Lower Range Limit (LRL) of
the Meter body and 2X the Upper
Range Limit (URL) of the Meter
body.
The LRV/URV value will be
available in Pressure Units (Simple
Display pressure unit)
Press  to
enter menu
selection
 Menu to
select
number.
 to enter and
shift to the
next digit to
the right