Honeywell SmartLine ST 800 - Page 53

43 ST 800 Pressure Transmitter User’s Manual Revision 15
Set LRV
[ 8SETLRV]
Set LRV
Executing this selection performing
for Zero operation. Note: The PV
value shown in bottom line will be
available in Pressure Units (Simple
Display pressure unit)
Press  to
enter menu
selection
Press  to
initiate action
Set URV
[ 9SETURV]
Set URV
Executing this selection for Span
operation
Note: The PV value shown in
bottom line will be available in
Pressure Units (Simple Display
pressure unit)
Contrast
[10CNTRST]
Contrast level
Adjust the LCD contrast level.
Range from » (1) to
»»»»»»»»» (7)
Default: »»»»»»» (7)
Press  to
enter Menu
selection
Menu to
select level.
 to Enter
LRV Corrects
[11LRVCOR]
Calibration Methods
Perform an input calibration
correction by applying process input
at the configured LRV level.
Press  to
enter menu
selection
Press  to
initiate action
URV Corrects
[12URVCOR]
Calibration Methods
Perform an input calibration
correction by applying process input
at the configured URV level.
Press  to
enter menu
selection
Press  to
initiate action
Reset Corrects
[13RSTCOR]
Calibration Methods
Executing this selection resets the
Zero, LRV, URV, Cal Low, Cal
High and Barometric Standard
Corrects back to factory values.
Press  to
enter menu
selection
Press  to
initiate action