Honeywell SmartLine ST 800 - Page 55

45 ST 800 Pressure Transmitter User’s Manual Revision 15
Language Selection
[20LNGSEL]
ENGLISH
RUSSIAN
Standard display language selection:
Select English or Russian option to
show display in selected language.
Press  to
enter menu
selection
Menu to
select from
list
 to enter
Transfer Function
[21TXFRFN]
LINEAR
SQRT
Pressure Transfer function: Select
the pressure transfer function for
calculated output: Linear: (output
scaled linearly per configured range)
Square Root: (output scaled as
square root conversion per
configured range - for flow
measurements)
Press  to
enter menu
selection
Menu to
select from
list
 to enter
Low Flow Cut Off
Mode
[22CUTFMD]
ZROFLOW
SBRKPT
DUALSLP
Low Flow Cutoff Mode:
For Square Root (Transfer function)
configurations only, choose the
operating mode to determine the low
flow cutoff breakpoint: Dual slope:
(breakpoint determined by dual slope
calculation) User configuration:
(breakpoint defined by user)
Zero Flow: sets analog output to
4mA when square root / flow is
below user defined flow cutoff
value.
Note: Sets loop output to low
saturation when the differential
pressure is below -10%Flow in Zero
Flow.
Press  to
enter menu
selection
Menu to
select from
list
 to enter
Low Flow Cut Off
Breakpoint
[23%FLOW]
##.#
When “User Configuration” is
selected for Low Flow Cutoff
Mode, enter the desired breakpoint
value.
Press  to
enter menu
selection
 to select
number.
 to enter and
shift to the
next digit to
the right
SP Zero Corrects
[24SPZRO]
Corrects the static
pressure to a zero- value
psi for DP transmitters
only
Performs the correction of measured
static pressure value to a value of
zero psi.
Executing this selection corrects
Static Pressure Zero based on the
input static pressure.
The live value of the static pressure
input is shown on this display so the
user can easily see the result of the
correction.
Press  to
enter menu
selection
Press  to
initiate action