Honeywell Xenon Series User Manual

94 Xenon/Granit User Guide
Number of Beeps - Base Error
The number of beeps and LED flashes emitted by the base for an error condition
can be programmed from 1 - 9. For example, if you program this option to have five
error beeps, there will be five error beeps and five LED flashes in response to an
error. To change the number of error beeps, scan the bar code below and then scan
a digit (1-9) from the Programming Chart, beginning on page 353, then Save.
Default = 1.
Scanner Report
Scan the bar code below to generate a report for the connected scanner. The report
indicates the port, scanner name, and address. To assign a name to your scanner,
refer to Menu Command Syntax,page 267.
Scanner Address
Scan the bar code below to determine the address of the scanner you are using.
Base Address
Scan the bar code below to determine the address of the base you are using.
Number of Base Error Beeps/LED Flashes
Scanner Report
Scanner Address
Base Address

Honeywell Xenon Series Specifications

General

IP Rating	IP42
Connectivity	USB, RS-232, Keyboard Wedge, IBM 46XX, Synapse, USB-CDC
Decode Capabilities	1D and 2D barcodes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Light Levels	Ambient light up to 100, 000 lux
Field of View	Horizontal: 41.4°; Vertical: 32.2°
Interface	USB, RS-232, Keyboard Wedge, IBM 46XX
Humidity	5% to 95% (non-condensing)
Dimensions	104 mm x 71 mm x 160 mm (4.1 in x 2.8 in x 6.3 in)
Drop Resistance	Withstands 50 drops at 1.8 m (6 ft) to concrete
Drop Specification	Withstands 50 drops at 1.8 m (6 ft) to concrete