Honeywell Xenon Series User Manual

Xenon/Granit User Guide 59
base and to set the alarm duration, scan the appropriate bar code below and then
set the time-out duration (from 0-3000 seconds) by scanning digits on the
Programming Chart, beginning on page 353, then Save. Default = 0 sec (no alarm).
Note: If you are out of range when you scan a bar code, you will receive an error tone even if
you do not have the alarm set. You receive the error tone since the data could not be
communicated to the base or Access Point or the host.
Alarm Sound Type
You may change the alarm type for the scanner or a CCB01-010BT base by scan-
ning the appropriate bar code below and then scanning a digit (0-7) bar code from
the Programming Chart, beginning on page 353, then Save. Default = 0.
The sounds are as follows:
Note: The Access Point does not have a base alarm.
Base Alarm Duration
Scanner Alarm Duration
Setting Sound
0 3 long beeps, medium pitch
1 3 long beeps, high pitch
2 4 short beeps, medium pitch
3 4 short beeps, high pitch
4 single chirps, medium pitch
5 2 chirps, then 1 chirp, medium pitch
6 single chirps, high pitch
7 2 chirps, then 1 chirp, high pitch
Note: Only the CCB01-010BT base has an alarm.
Base Alarm Type
Scanner Alarm Type

Honeywell Xenon Series Specifications

General

IP Rating	IP42
Connectivity	USB, RS-232, Keyboard Wedge, IBM 46XX, Synapse, USB-CDC
Decode Capabilities	1D and 2D barcodes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Light Levels	Ambient light up to 100, 000 lux
Field of View	Horizontal: 41.4°; Vertical: 32.2°
Interface	USB, RS-232, Keyboard Wedge, IBM 46XX
Humidity	5% to 95% (non-condensing)
Dimensions	104 mm x 71 mm x 160 mm (4.1 in x 2.8 in x 6.3 in)
Drop Resistance	Withstands 50 drops at 1.8 m (6 ft) to concrete
Drop Specification	Withstands 50 drops at 1.8 m (6 ft) to concrete