Honeywell Xenon Series User Manual

Xenon/Granit User Guide 63
Batch Mode Beep
When scanning in Inventory Batch Mode (page 62), the scanner beeps every time a
bar code is scanned. If using a Granit scanner, it also vibrates. When Batch Mode
Beep is On, you will also hear a click when each bar code is sent to the host. If you
do not want to hear these clicks, scan Batch Mode Beep Off. Default = Batch Mode
Beep On.
Batch Mode Storage
When a scanner is storing data during a Batch Mode process, you can select
whether the data is stored in Flash memory or in RAM.
Flash Storage: The scanner writes any untransmitted data to flash memory prior to
powering down. The data will still be there when the scanner powers back up. How-
ever, the scanner will power down, even with untransmitted data, if it reaches a
power down timeout or if the battery power is very low.
RAM Storage: The scanner will not power down while it contains data that has not
been transmitted to the base or Access Point, even if it reaches a power down time-
out. However, if the scanner runs out of battery power, it will power down and the
data will be lost.
Default = Flash Storage.
Batch Mode Beep Off
* Batch Mode Beep On
* Flash Storage
RAM Storage

Honeywell Xenon Series Specifications

General

IP Rating	IP42
Connectivity	USB, RS-232, Keyboard Wedge, IBM 46XX, Synapse, USB-CDC
Decode Capabilities	1D and 2D barcodes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Light Levels	Ambient light up to 100, 000 lux
Field of View	Horizontal: 41.4°; Vertical: 32.2°
Interface	USB, RS-232, Keyboard Wedge, IBM 46XX
Humidity	5% to 95% (non-condensing)
Dimensions	104 mm x 71 mm x 160 mm (4.1 in x 2.8 in x 6.3 in)
Drop Resistance	Withstands 50 drops at 1.8 m (6 ft) to concrete
Drop Specification	Withstands 50 drops at 1.8 m (6 ft) to concrete