Honeywell Xenon Series User Manual

Xenon/Granit User Guide 243
B - Beeper
Causes a beep to sound after an image is snapped.
0B No beep (default)
1B Sounds a beep when the image is captured.
T - Wait for Trigger
Waits for a hardware trigger press before taking the image. This is only available
when using Photo Style (1P).
0T Takes image immediately (default)
1T Waits for a trigger press, then takes the image
L - LED State
Determines if the LEDs should be on or off, and when. Ambient illumination (0L) is
preferred for taking pictures of color documents, such as ID cards, especially when
the scanner is in a stand. LED illumination (1L) is preferred when the scanner is
handheld. LED State is not available when using Decoding Style (0P).
0L LEDs off (default)
1L LEDs on
E - Exposure
Exposure is used in Manual Style only (2P), and allows you to set the exposure
time. This is similar to setting a shutter speed on a camera. The exposure time
determines how long the scanner takes to record an image. On a bright day, expo-
sure times can be very short because plenty of light is available to help record an
image. At nighttime, exposure time can increase dramatically due to the near
absence of light. Units are 127 microseconds. (Default = 7874)
nE Range: 1 - 7874
Example:
Exposure at 7874E with
fluorescent lighting:
Exposure at 100E with
fluorescent lighting:

Honeywell Xenon Series Specifications

General

IP Rating	IP42
Connectivity	USB, RS-232, Keyboard Wedge, IBM 46XX, Synapse, USB-CDC
Decode Capabilities	1D and 2D barcodes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Light Levels	Ambient light up to 100, 000 lux
Field of View	Horizontal: 41.4°; Vertical: 32.2°
Interface	USB, RS-232, Keyboard Wedge, IBM 46XX
Humidity	5% to 95% (non-condensing)
Dimensions	104 mm x 71 mm x 160 mm (4.1 in x 2.8 in x 6.3 in)
Drop Resistance	Withstands 50 drops at 1.8 m (6 ft) to concrete
Drop Specification	Withstands 50 drops at 1.8 m (6 ft) to concrete