Honeywell Xenon Series User Manual

CHAPTER
15
Xenon/Granit User Guide 331
MAINTENANCE AND
TROUBLESHOOTING
Repairs
Repairs and/or upgrades are not to be performed on this product. These services
are to be performed only by an authorized service center (see Customer Support on
page xvii).
Maintenance
Your device provides reliable and efficient operation with a minimum of care.
Although specific maintenance is not required, the following periodic checks
ensure dependable operation:
Clean the Scanner
The scanner or base’s housing may be cleaned with a soft cloth or tissue damp-
ened with water (or a mild detergent-water solution.) If a detergent solution is used,
rinse with a clean tissue dampened with water only.
Clean the Window
Reading performance may degrade if the scanner’s window is not clean. If the win-
dow is visibly dirty, or if the scanner isn’t operating well, clean the window with one
of the cleaning solutions listed for Health Care Housing, below.
Caution: Do not submerge the scanner in water. The scanner’s housing is
not watertight. Do not use abrasive wipes or tissues on the
scanner’s window. Abrasive wipes may scratch the window.
Never use solvents (e.g., acetone) on the housing or window.
Solvents may damage the finish or the window.

Honeywell Xenon Series Specifications

General

IP Rating	IP42
Connectivity	USB, RS-232, Keyboard Wedge, IBM 46XX, Synapse, USB-CDC
Decode Capabilities	1D and 2D barcodes
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Light Levels	Ambient light up to 100, 000 lux
Field of View	Horizontal: 41.4°; Vertical: 32.2°
Interface	USB, RS-232, Keyboard Wedge, IBM 46XX
Humidity	5% to 95% (non-condensing)
Dimensions	104 mm x 71 mm x 160 mm (4.1 in x 2.8 in x 6.3 in)
Drop Resistance	Withstands 50 drops at 1.8 m (6 ft) to concrete
Drop Specification	Withstands 50 drops at 1.8 m (6 ft) to concrete