99
• You have read and write permissions to the server.
To back up the main next-startup configuration file to a TFTP server:
Step Command Remarks
1. (Optional.) Verify that a
next-startup configuration file
has been specified in user
view.
display startup
If no next-startup configuration file
has been specified, the backup
operation will fail.
2. Back up the next-startup
configuration file to a TFTP
server in user view.
backup startup-configuration to
dest-addr [dest-filename ]
This command is not supported in
FIPS mode.
Restoring the main next-startup configuration file
from a TFTP server
To restore the main next-startup configuration file from a TFTP server, the device performs the following
operations:
• Downloads a configuration file from a TFTP server to the root directory of each member's flash
memory.
• Specifies the file as the main next-startup configuration file.
Before restoring the next-startup configuration file, make sure the following requirements are met:
• The server is reachable.
• The server is enabled with TFTP service.
• You have read and write permissions to the server.
To restore the main next-startup configuration file from a TFTP server:
Step Command Remarks
1. Restore the main next-startup
configuration file from a TFTP
server in user view.
restore startup-configuration from
src-addr src-filename
This command is not supported in
FIPS mode.
2. (Optional.) Verify that the
specified configuration file has
been set as the main
next-startup configuration file.
display startup
display saved-configuration
N/A
Deleting a next-startup configuration file
CAUTION:
This task permanently deletes the next-startup configuration file from all member devices. Before
performing this task, back up the file as needed.
Delete the next-startup configuration file if one of the following occurs:
• After you upgrade system software, the file no longer matches the new system software.
To Next Page
Loading...
Need help?
General
