79
Task Command
Display source IP address
information on the FTP client
display ftp client source
FTP client configuration example
Network requirements
• Use the IRF fabric that comprises two member devices as the FTP client and the PC as the FTP server.
• Log in to the FTP server from the FTP client using the user account with username abc and password
123 456 (which has been created on the PC).
• Download the file temp.bin from the FTP server to the FTP client, and upload the configuration file
config.cfg from the FTP client to the FTP server for backup.
Figure 26 Network diagram
Configuration procedure
# Configure IP addresses as shown in Figure 26 and make sure the IRF fabric and PC can reach each
other. (Details not shown.)
# Examine the storage space on the member devices. If the free space is insufficient, use the
delete/unreserved file-url command to delete unused files. (Details not shown.)
# L o g i n t o t h e F T P s e r v e r a t 10 .1.1.1 u s i n g t h e u s e r n a m e abc and password 123 456 .
<Sysname> ftp 10.1.1.1
Press CTRL+C to abort.
Connected to 10.1.1.1 (10.1.1.1).
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User (10.1.1.1:(none)): abc
331 Give me your password, please
Password:
230 Logged in successfully
Remote system type is MSDOS.
ftp>
# Set the file transfer mode to binary.
ftp> binary
200 TYPE is now 8-bit binary
Internet
IRF (FTP client)
IP:
10.2.1.1/16
Master
(Member_ID=1)
Subordinate
(Member_ID=2)
10.1.1.1/16
FTP server
PC
Note: The orange line represents an IRF connection.
To Next Page
Loading...
Need help?
General
