HP 5920 Series Fundamentals Configuration Guide

38
Accessing the device through SNMP
You can run SNMP on an NMS to access the device MIB and perform Get and Set operations to manage
and monitor the device.
Figure 15 SNMP access diagram
The device supports SNMPv1, SNMPv2c, and SNMPv3, and can work with various network
management software products, including IMC. However, the device and the NMS must use the same
SNMP version. For more information about SNMP, see Network Management and Monitoring
Configuration Guide.
By default, SNMP access is disabled. To access the device through SNMP, you must log in to the device
through any other method and configure SNMP access.
Configuring SNMPv3 access
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the SNMP
agent.
snmp-agent
By default, the SNMP agent is
disabled.
3. (Optional.) Create
or update MIB
view information.
snmp-agent mib-view { excluded | included }
view-name oid-tree [ mask mask-value ]
By default, the device has four
views, all of which are named
ViewDefault:
• View 1 includes MIB subtree
iso.
• View 2 does not include
subtree snmpUsmMIB.
• View 3 does not include
subtree snmpVacmMIB.
• View 4 does not include
subtree snmpModules.18.
4. Create an
SNMPv3 group.
snmp-agent group v3 group-name
[ authentication | privacy ] [ read-view
view-name ] [ write-view view-name ]
[ notify-view view-name ] [ acl acl-number | acl
ipv6 ipv6-acl-number ] *
By default, no SNMPv3 group
exists.
Agent
NMS
MIB
Get/Set requests
Get/Set responses
and Traps

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English