47
Ste
Command
Remarks
3. Enable scheme
authentication.
authentication-mode scheme
By default, authentication is disabled for
AUX lines, and password authentication is
enabled for VTY lines.
In VTY line view, this command is
associated with the protocol inbound
command:
• If the setting of either command is not
the default in VTY line view, the setting
of the other command in VTY line view
takes effect.
• If the settings of both commands are the
defaults in VTY line view, the settings of
the commands in VTY line class view
take effect.
4. Enable command
accounting.
command accounting
By default, command accounting is
disabled, and the accounting server does
not record the commands executed by
users.
If the command accounting command is
configured in user line class view,
command accounting is enabled on all
user lines in the class, and you cannot
configure the undo command accounting
command in the view of a user line in the
class.
Configuration example
Network requirements
To monitor and control user operations on the device in Figure 19, configure the device to send
commands executed by users to the HWTACACS server.
To Next Page
Loading...
Need help?
General
