HP 5920 Series Fundamentals Configuration Guide

30
Ste
p
Command Remarks
8. Set the size of
command history
buffer.
history-command max-size
value
By default, the buffer saves 10 history
commands.
9. Set the session idle
timeout.
idle-timeout minutes
[ seconds ]
By default, the session idle timeout is 10 minutes
for all user lines.
If there is no interaction between the device and
the user within the idle timeout, the system
automatically terminates the user connection on
the user line.
If you set the idle timeout to 0, the session will not
be aged out.
10. Specify a command to
be automatically
executed when users
log in to the user lines.
auto-execute command
command
By default, no automatically executed command
is specified.
Using the device to log in to a Telnet server
You can use the device as a Telnet client to log in to a Telnet server. If the server is located in a different
subnet than the device, make sure the two devices have routes to reach each other.
Figure 8 Telnetting from the device to a Telnet server
To use the device to log in to a Telnet server:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. (Optional.) Specify the
source IPv4 address or
source interface for
outgoing Telnet packets.
telnet client source { interface
interface-type interface-number | ip
ip-address }
By default, no source IPv4
address or source interface is
specified, and the primary IPv4
address of the outbound
interface is used as the source
address for outgoing Telnet
packets.
3. Exit to user view.
quit N/A

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English