HP 5920 Series

169
Ste
p
Command Remarks
4. Configure the address
pool.
• (Method 1.) Specify the
primary subnet for the
address pool:
network network-address
[ mask-length | mask mask ]
• (Method 2.) Configure a static
binding:
static-bind ip-address
ip-address [ mask-length |
mask mask ] { client-identifier
client-identifier |
hardware-address
hardware-address [ ethernet
| token-ring ] }
Use either or both methods.
By default, no primary subnet or static
binding is configured.
You can add multiple static bindings.
One IP address can be bound to only one
client. To change the binding for a DHCP
client, you must delete the binding and
reconfigure a binding.
5. Specify the URL of the
configuration file or script
file.
bootfile-name url
By default, no configuration file URL is
specified.
Configuring the DHCP server when a TFTP file server is used
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable DHCP.
dhcp enable By default, DHCP is disabled.
3. Create a DHCP address
pool and enter its view.
dhcp server ip-pool pool-name
By default, no DHCP address
pool is created.
4. Configure the address
pool.
• (Method 1.) Specify the primary subnet
for the address pool:
network network-address [ mask-length
| mask mask ]
• (Method 2.) Configure a static binding:
static-bind ip-address ip-address
[ mask-length | mask mask ]
{ client-identifier client-identifier |
hardware-address hardware-address
[ ethernet | token-ring ] }
Use either or both methods.
By default, no primary subnet or
static binding is configured.
You can add multiple static
bindings.
One IP address can be bound
to only one client. To change
the binding for a DHCP client,
you must delete the binding and
reconfigure a binding.
5. Specify a TFTP server.
• (Method 1.) Specify the IP address of
the TFTP server:
tftp-server ip-address ip-address
• (Method 2.) Specify the name of the
TFTP server:
tftp-server domain-name
domain-name
Use either or both methods.
By default, no TFTP server is
specified.
If you specify a TFTP server by
its name, a DNS server is
required on the network.
6. Specify the configuration
file name.
bootfile-name bootfile-name
By default, no configuration file
name is specified.
Configuring the DNS server
A DNS server is required in the following situations: