HP 5920 Series Fundamentals Configuration Guide

33
Ste
p
Command Remarks
7. (Optional.) Specify
the protocols for the
user lines to support.
• In non-FIPS mode:
protocol inbound { all | ssh
| telnet }
• In FIPS mode:
protocol inbound ssh
In non-FIPS mode, Telnet and SSH are
supported by default.
In FIPS mode, SSH is supported by default.
This configuration takes effect only for users
who log in to the user lines after the
configuration is completed.
In VTY line view, this command is associated
with the authentication-mode command:
• If the setting of either command is not the
default in VTY line view, the setting of the
other command in VTY line view takes
effect.
• If the settings of both commands are the
defaults in VTY line view, the settings of the
commands in VTY line class view take
effect.
8. (Optional.) Set the
maximum number of
concurrent SSH users.
aaa session-limit ssh
max-sessions
By default, the maximum number of concurrent
SSH users is 16.
Changing this setting does not affect online
users. If the current number of online SSH users
is equal to or greater than the new setting, no
additional SSH users can log in until the online
users log out.
For more information about this command, see
Security Command Reference.
9. Exit to system view.
quit N/A
10. (Optional.) Configure
common settings for
VTY lines.
See "Configuring common VTY
line settings."
N/A
Using the device to log in to an SSH server
You can use the device as an SSH client to log in to an SSH server. If the server is located in a different
subnet than the device, make sure the two devices have routes to reach each other.
Figure 9 Logging in to an SSH client from the device
Perform the following tasks in user view:
Task Command
Log in to an IPv4 SSH server. ssh2 server
Log in to an IPv6 SSH server. ssh2 ipv6 server

HP 5920 Series Specifications

General

Brand	HP
Model	5920 Series
Category	Switch
Language	English