178
Figure 44 Network diagram
Configuration procedure
1. Assign IP addresses to the interfaces. Make sure the devices can reach each other. (Details not
shown.)
2. Configure the following files on the HTTP server:
File Content
Remarks
.cfg configuration file Commands required for IRF setup.
You can create a configuration file by
copying and modifying the
configuration file of an existing IRF
fabric.
sn.txt
Serial numbers of the member
switches.
Each SN uniquely identifies a switch.
These SNs will be used for assigning
a unique IRF member ID to each
member switch.
(Optional.) .ipe or .bin
software image file
Software images.
If the member switches are running
different software versions, you must
prepare the software image file used
for software upgrade.
To Next Page
Loading...
Need help?
General
