165
Chapter 6, Call Processing Subsystem
CALL BIT Screen
NOTE: The contents of the applicable fields on the CALL CONTROL screen and the CALL
CONFIGURE screen are not updated to reflect any changes made while in the Bits mode.
There is no coupling between the Bits mode and the Test Set. For example: if a mobile station
was actively connected to the Test Set on a voice channel and the user changed the CHAN field
on the forward voice channel mobile station control message (FVC V Mes) and sent that
message to the mobile station, the mobile station would change its voice channel assignment.
However, the Test Set will stay on the voice channel assignment specified in the Chan: field
on the CALL CONTROL screen. This situation will result in a dropped call. The Bits mode
should not be used to change any parameter that can be set on any other Call Processing
Subsystem screen.
Handoff
This field is used to initiate a handoff from the current voice channel assignments
to a new set of voice channel assignments. The voice channel number to hand the
mobile station off to, the initial power level to use on the new voice channel, and
the SAT tone frequency to transpond on the new voice channel are specified using
the Chan:, Pwr Lvl:, and SAT: fields in the Voice Channel Assignment
section of the CALL CONTROL screen.
Order
This field is used to send an order type mobile station control message on the
forward voice channel to the mobile station. The orders available are:
• Change Power to Power Level 0 - 7
• Maintenance (put the mobile station in maintenance mode)
• Alert (alert the mobile station)
The Order field is a one-of-many selection field. To send an order to the mobile
station select the Order field. A list of choices is displayed. Select the desired
order from the Choices: menu. Once the selection is made, a Mobile Station
Control Message is sent to the mobile station. The Access annunciator will light
momentarily while the Test Set is sending the mobile station control message.
To Next Page
