HP 8921A - Page 566

Index
566
view of, 118
AMPS-TACS
control channel decoder, 217
forward control channel, 301
forward voice channel, 301
radio standard, 312
reverse control channel, 222
reverse voice channel, 222
simulated system, 128
voice channel decoder, 217
AMPS-TACS decoder mode
AF Anl In, 218
Arm Meas, 218
Channel, 218
Data (hex), 219
Gate Time, 219
Input Level, 219
Num of Bits, 220
Polarity, 220
Single/Cont, 221
Stop Meas, 221
Trig Level, 221
Trigger Pattern (bin), 221
view of, 217
AMPS-TACS encoder mode
AFGen2 To, 302
Audio Out, 302
B/I Delay, 303
Bursts, 303
Busy/Idle, 303
Channel, 303
Data Level, 303
Data Rate, 304
Filler, 305
FM Coupling, 306
Message, 307, 308
Polarity, 310
SAT Freq, 311
SAT Level, 311
Send, 311
Send Filler, 311
Send Mode, 312
Standard, 312
Stop, 312
Stop Filler, 312
view of, 301
Analog Meas screen
AF Anl In, 192
AF Freq, 193
AFGen1 Freq, 193
AFGen1 To, 193
Amplitude, 193
De-Emphasis, 193
Detector, 194
Filter 1, 194
Filter 2, 194
FM Deviation, 194
TX Freq Error, 194
TX Power, 194
view of, 192
analog meter, 62
analyzer
arming measurements, 221, 229, 234,
238, 243, 249, 254, 266, 283
calibration, 464
disarming measurements, 243
frequency, markers, 460
input port, 454
level, markers, 460
analyzer, AF
CDCSS decoder settings, 230
input, 218, 226, 231, 235, 241, 247,
251, 263, 281
level, 219, 228, 233, 237, 242, 248,
252, 265, 282
analyzer, RF
frequency, 297, 425, 504
input attenuation, 421
input port, 422
level, 419
measurements, 424
sensitivity, 423
tuning, 297, 425, 504
ANT IN connector
avoiding damage, 58, 91, 108, 295,
298, 422, 426, 454, 503, 505, 508
connecting to, 40, 454
description, 508
for ACP ratio measurements, 87, 91
for off-the-air measurements, 91, 256,
295, 422, 503
for RF measurements, 91, 295, 422,
503
gain at, 202
input attenuation, 90, 421, 461
loss at, 202
sensitivity, 423, 463
Antenna In
Configure screen, 202
Area #
Signaling Encoder screen, NMT mode,
369
Area 1
Signaling Encoder screen, LTR mode,
343
Area 2
Signaling Encoder screen, LTR mode,
343
arm
measurment, 218, 221, 227, 229, 231,
234, 235, 238, 242, 243, 248, 249,
251, 254, 266, 281, 283
radio interface interrupt, 407
Arm Meas
Signaling Decoder screen, AMPS-
TACS mode, 218
Signaling Decoder screen, CDCSS
mode, 227
Signaling Decoder screen, Digi Page
mode, 231
Signaling Decoder screen, DTMF
mode, 235
Signaling Decoder screen, EDACS
mode, 242
Signaling Decoder screen, Func Gen
mode, 248
Signaling Decoder screen, LTR mode,
251
Signaling Decoder screen, NAMPS-
NTACS mode, 218
Signaling Decoder screen, Tone Seq
mode, 281
arrow down key, 527
arrow left key, 529
arrow up key, 527
ASCII terminal, 81
configuring, 388
ASSIGN, 77, 78
Atten Hold
Duplex Test screen, 291
RF Generator screen, 434
RX Test screen, 444
attenuation
automatic control, 90, 421, 461