FINAL TRIM SIZE : 7.0 in x 8.5 in
5
7. Within the \Select a Disk to Add" windo
w, highlight the line iden
tifying
the new driveyou have just connected. It will b e describ ed as, for example,
\CD ROM-SCSI", followed by its mo del numb er and bus address. Clic
kon
NNNNNNNN
OK
or press
4
Return
5
.
If the device you have connected do es
not
appear on the list:
a. Checkyour hardware connections, and make sure that the device is
turned
on
and that there is a disc in it.
b. Click on the button
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Device Missing
, and you will b e giv
en the
following options:
i. Have SAM rescan the system for the device. If y
ou have connected
the device
after
starting SAM, you should clickon
NNNNNNNNNNN
Yes
. Otherwise,
clickon
NNNNNNNN
No
.
ii. Respond to the conrmation screen regarding whether the device is
connected and powered up.
iii. Respond to the conrmation screen regarding whether additional
device drivers are needed.
iv. You will b e given an information screen suggesting things to try if
the device still cannot be found. If this is the case, y
ou will need to
consult
Instal ling Peripherals
.
8.
From the
NNNNNNNNNNNNNNNNNNNNNNN
Actions
menu, select
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Add a Hard Disk Drive
.You will see a
form giving three tasks:
a.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Select a Disk to Add
. (Make sure the correct device is displa
yed
and highlighted).
b. If you need to add drivers to the kernel, SAM will prompt you for
doing so and will ask whether you wish to recreate the kernel nowor
later. Make this selection by pressing
4
Return
5
when your selection is
highlighted. Then the selection is designated by an asterisk (*) in its
blank. Clickon
NNNNNNNN
OK
to activate that selection.
c.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Set Disk Usage and Options
. (File system usage is already set for a
CD ROM.)
5-22 Configuring HP-UX for Printers and Drives DRAFT
2/5/97 11:31