HP 9000 Series - Mounting a New Flexible Disk; Removing and Inserting a File-System Flexible Disk

FINAL TRIM SIZE : 7.0 in x 8.5 in
5
Mounting a New Flexible Disk
If you want HP-UX to b e able to address a newly-inserted exible disk as a
small le system, you will need to moun
t it. Execute the following to moun
t
the new disk. For example, using \ /flex " as the mount directory:
mount /dev/floppy/c201d0s0 /flex
See the next section for information on moun
ting and unmounting a disk used
as a le system.
Removing and Inserting a File-System Flexible Disk
Caution
If you wish to use the disk as a mounted le system, you must
mountit every time you insert it into the drive, and you must
unmount the disk b efore you eject it from the drive.
You will need to do the follo wing:
Before you remove a disk:
1. Temp orarily unmount the le system for the disk by executing the
following. For example, if the disk is designated b
y the blo ck device le
/dev/floppy/c201d0s0 :
umount /dev/floppy/c201d0s0
2. Remove the disk.
5-18 Configuring HP-UX for Printers and Drives DRAFT
2/5/97 11:31