FINAL TRIM SIZE : 7.0 in x 8.5 in
5
After you insert a disk:
1. Mount the disk le system so that HP-UX will recognize it. If, for
example, you are mounting the disk in a driv
e designated by the device
le
/dev/floppy/c201d0s0
under a pre-existing directory
/flex
, execute
the following:
mount /dev/floppy/c201d0s0 /flex
(Note that the directory
/flex
, in the example, must b e giv
en an absolute
path name).
In this example, the
mount
command announces to the system that a
removable le system is to be attached at the directory
/flex
.
2. Nowyou can access the exible disk as y
ou would any other disk.
DRAFT
2/5/97 11:31
Configuring HP-UX for Printers and Drives 5-19
To Next Page
Loading...
