FINAL TRIM SIZE : 7.0 in x 8.5 in
5
Configuring for a CD ROM Driv
e
You can use a CD R
OM (\Compact Disc Read-Only Memory") driv
eto
accommo date read-only use of a wide v
ariety of softw
are, including HP-UX
system updates.
After hardware installation for a driv
e has been completed (see \Hardw
are
Installation for Drives" and the
Instal lation Guide
for this device), y
ou'll
need to ensure that y
our op erating system is prepared to exc
hange data with
the device. This section pro
vides instructions for conguring HP-UX to
communicate with the CD R
OM drive.
Note
The use of audio-mo de for a CD R
OM is not supp orted.
The CD ROM drive cannot b e lo cally-mounted on a diskless
node, although its driver must b e congured into each cluster
node's kernel.
This section deals with the following topics:
Installing the CD ROM with SAM.
Testing the installation.
Mounting the new CD ROM.
Removing and inserting a disc.
The factory-set SCSI address for this device:
SCSI bus address:
2
As it is possible that the CD R
OM drivemay b e shipp ed with a dierent SCSI
bus setting, please see the
Instal lation Guide
for the device for guidance on
resetting it, if necessary.
Inserting the disc in your CD ROM drive.
Note that a rigid plastic caddy holds and protects the disc. Before inserting
the disc, make sure you have the disc installed in the appropriate disc caddy.
When inserted into the disc p ort, data is read from the disc through a shutter
in the caddy. When you eject the caddy, the shutter closes to protect the disc's
data surface.
5-20 Configuring HP-UX for Printers and Drives DRAFT
2/5/97 11:31
To Next Page
Loading...
Need help?
General
