FINAL TRIM SIZE : 7.0 in x 8.5 in
5
Preparing for Installation
If your system was shipp ed with its in
ternal mass storage devices
factory-installed, you will not need to do further installation to enable the
device to communicate with HP-UX. If you have purchased a new (upgrade)
device, you will have to install it on HP-UX. Y
ou may also have to do some
conīguration for appropriate data in
terchange with a new printer. This chapter
gives you general guidance for these tasks.
For p eripherals devices in general:
For a list of device upgrades whic
h are supported b
y the Mo dels 745i/50 or
745i/100 and 747i/50 or 747i/100, see Chapter 1.
See the
Instal lation Guide
for the device you are installing for information
on hardware installation. You can also get installation information from
Instal ling Peripherals
.
Ensure that each new device you install which communicates through the
SCSI proto col has a
unique bus address
.You can use
/etc/ioscan
(see
\Finding the Status of Existing SCSI Bus Addresses") to determine this, or
you can use SAM (System Administration Manager). The factory-set SCSI
addresses for the upgrade devices in this chapter are as follows:
Hard Disk Drive:
6
Flexible Disk Drive:
0
CD ROM Drive:
2
DDS Drive:
3
This chapter shows you how to use basic SAM (System Administration
Manager) pro cedures. SAM will determine the status of an
yofyour
connected devices and will perform many installation tasks for you.
If you don't want to use SAM, or it is not on your system, you can also
HP-UX commands directly to accomplish the same tasks. For information on
using manual system administration pro cedures, see
System Administration
Tasks
.
5-2 Configuring HP-UX for Printers and Drives DRAFT
2/5/97 11:31
To Next Page
Loading...
