Enclosure troubleshooting 36
Error indication Initial step Required steps
A server blade is powered up.
The following conditions exist:
The power LED is green.
The health LED is green.
The Insight Display device bay
status is blue.
No iLO 2 IP address results in
the following conditions:
No iLO 2 web or SSH
access
No enclosure DVD-ROM
drive support for this server
blade
No server blade information
provided to the Onboard
Administrator
No remote console or
remote media support
The iLO 2 on this server blade has no
IP address.
To configure the iLO 2 IP address,
reboot the server blade and use the
iLO 2 ROM setup during POST.
A server blade is powered up.
The following conditions exist:
The power LED is green.
The health LED is green.
The Insight Display device bay
status is red.
This issue results in the following
conditions:
The enclosure fan speed is
elevated to protect the server
blade.
The server blade cannot be
powered up if it was
manually powered down.
The Onboard Administrator
report of server blade
thermals and status is not
accurate.
The Onboard Administrator has lost
power and cooling communication
with iLO 2 for this server blade.
To reset iLO 2, perform one of the
following actions:
Log in to the iLO 2 GUI and reset
iLO 2.
Use the OA CLI command for the
bay, where N is the device bay
number.
reset server N
Because the previous action requires
restarting the server blade, always
request permission to power down the
server blade before performing this
action:
For an alternative method for resetting
iLO 2, reseat the server blade.
Reseating the server blade powers off
the server blade and iLO 2.
A server blade is powered up.
The following conditions exist:
The power LED is green.
The health LED is flashing red.
The Insight Display device bay
status is bright green.
—
The server blade failed to complete
POST. To troubleshoot the memory
installation, perform the following
steps:
1 Remove the server blade.
2 Verify that the memory is installed
according to the installation
guidelines provided in the server
blade documentation.
3 Install the server blade in the
original device bay.
4 Review the IML for this server
blade from OA GUI/CLI.
5 Review the iLO log from this server
blade for indicators.
To Next Page
Loading...
