Adjusting the height-adjustable/reclining stand (optional)
This stand allows you to:
●
adjust the computer height 110 mm (4.3 inches)
●
rotate the computer position from landscape to portrait
●
recline the computer backward up to +60 degrees
●
tilt the computer to 30 degrees from the desktop
●
swivel the computer up to 360 degrees right or left
To rotate the computer:
1. Grasp the computer by the sides and lift it straight up (1) to its highest position.
2. Press the top of the computer backwards (2).
CAUTION: The computer must be raised and tilted to provide clearance for rotating it.
3. Grasp the top right and bottom left of the computer and carefully turn it counterclockwise (3) until it is
in the portrait position (4).
WARNING! If the height-adjustable/reclining stand is installed, before laying the computer down for
service, first grasp the sides of the display and raise the display to the highest position.
Do not lay the computer down with the sliding stand in the low position. The stand may suddenly release,
which could cause injury or damage to equipment.
ENWW Positioning the computer 7
To Next Page
Loading...
Need help?
General