Stand
Description
Tilt/swivel stand
Height adjustment stand
Two stands are available for the computer:
●
Height-adjustable/recline stand
●
Tilt/swivel stand
Height-adjustable/recline stand (optional)
To remove the stand:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 27).
2. Place the computer face down on a soft flat surface. HP recommends that you set down a blanket,
towel, or other soft cloth to protect the bezel and screen surface from scratches or other damage.
WARNING! Before laying the computer down for service, first grasp the sides of the display and raise
the display to the highest position.
Do not lay the computer down with the sliding stand in the low position. The stand may suddenly
release, which could cause injury or damage to equipment.
ENWW Stand 29
To Next Page
Loading...
