Power supply
The power supply is located in the middle of the computer under the VESA mounting plate. It is secured with
two Torx screws and has one connector routed to the system board.
To remove the power supply:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 27).
2. Remove the stand (see
Stand on page 29).
3. Remove the access panel (see
Access panel on page 33).
4. Remove the lower rear panel (see
Lower rear panel on page 59).
5. Disconnect the cable from the system board connector (1).
6. Remove the two Torx screws (2) that secure the power supply to the computer.
74 Chapter 5 Removal and Replacement Procedures ENWW
To Next Page
Loading...
