15. The display panel cable is connected to the bottom of the panel. After lifting the panel up from the
bezel, look underneath to see the connected display panel cable. Lift the cable from the bottom of the
panel to disengage it from the adhesive that secures it to the panel, and then disconnect the display
cable from the display panel by pressing in on the tabs on the side of the connector, and then pulling
the cable from the connector.
To install the front bezel, reverse the removal procedures.
Be sure to correctly position the jumpers on the converter board for the installed display panel. The jumper
settings are shown on a label near the converter board.
ENWW Front bezel and display panel 89
To Next Page
Loading...
