HP Enterprise ProLiant DL380 Gen10 - Removing and Replacing the Cable Management Arm

Removing and replacing the cable management armRemoving and replacing the cable management arm
IMPORTANT: IMPORTANT: Support the CMA during the removal/replacement procedure. Do not allow it to hang by its own weight
during the procedure.
ProcedureProcedure
1. Extend the server from the rack .
2. Open the cable clamps and remove the cables routed through the CMA.
3. Remove the CMA from the rack.
a. Press the latch on the outer rail of the right CMA and slide out the CMA arm.
b. Press the blue latch on the left inner and outer rails of the CMA.
c. Remove the CMA.
To replace the component, reverse the removal procedure.
Removing and replacing the cable management arm 111