HP Enterprise ProLiant DL380 Gen10 - Removing and Replacing the Tertiary Pcie Riser Cage

Removing and replacing the tertiary PCIe riser cageRemoving and replacing the tertiary PCIe riser cage
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either
an expansion slot cover or an expansion board installed.
ProcedureProcedure
1. Power down the server ( Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect any external cables that are connected to the expansion board.
4. Do one of the following:
Extend the server from the rack ( Extend the server from the rack ).
Remove the server from the rack ( Remove the server from the rack ).
5. Remove the access panel ( Remove the access panel).
6. Disconnect any internal cables that are connected to the expansion board.
7. If any full-length expansion boards are installed, release the full-length expansion board retainer (Release the full-length expansion
board retainer).
8. Remove the PCIe riser cage.
To replace the component, reverse the removal procedure.
Removing and replacing the tertiary PCIe riser cage 127