Removing a hot-plug SAS/SATA basic driveRemoving a hot-plug SAS/SATA basic drive
CAUTION: CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or
blanks installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
1. Determine the status of the drive from the hot-plug drive LED definitions.
2. Back up all server data on the drive.
3. Remove the drive.
Figure 1: SFF driveFigure 1: SFF drive
Figure 2: LFF driveFigure 2: LFF drive
To Next Page
Loading...
