Removing and replacing a 4 LFF midplane cageRemoving and replacing a 4 LFF midplane cage
ProcedureProcedure
1. Power down the server (Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack ( Extend the server from the rack ).
Remove the server from the rack ( Remove the server from the rack ).
4. Remove the access panel ( Remove the access panel).
5. If installed, remove all riser cages:
Primary or secondary PCIe riser cage ( Removing and replacing the primary or secondary PCIe riser cages )
Tertiary PCIe riser cage (Removing and replacing the tertiary PCIe riser cage )
6. Disconnect the power and cables from the drive cage.
7. Raise the blue tabs on the drive tray and lift the drive cage to a 15 degree angle.
8. Pull the plunger pin to disengage it.
9. Remove all drives ( Removing and replacing drives).
10. Using both hands, remove the drive cage from the server.
To Next Page
Loading...
