HP Enterprise ProLiant DL380 Gen10 - Removing and Replacing the Pcie Riser Board

Removing and replacing the PCIe riser boardRemoving and replacing the PCIe riser board
ProcedureProcedure
1. Power down the server (Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack ( Extend the server from the rack ).
Remove the server from the rack ( Remove the server from the rack ).
4. Remove the access panel ( Remove the access panel).
5. If any full-length expansion boards are installed, release the full-length expansion board retainer (Release the full-length expansion
board retainer).
6. Remove the PCIe riser cage:
Primary or secondary PCIe riser cage ( Removing and replacing the primary or secondary PCIe riser cages )
Tertiary PCIe riser cage (Removing and replacing the tertiary PCIe riser cage )
7. Remove any expansion boards from the PCIe riser cage.
8. Remove the PCIe riser board:
Primary/secondary riser cage
Tertiary riser cage
Removing and replacing the PCIe riser board 130