HP Enterprise ProLiant DL380 Gen10 - Removing and Replacing a Rear Serial Port Interface (Tertiary Riser)

Removing and replacing a rear serial port interface (tertiary riser)Removing and replacing a rear serial port interface (tertiary riser)
ProcedureProcedure
1. Power down the server (Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack ( Extend the server from the rack ).
Remove the server from the rack ( Remove the server from the rack ).
4. Remove the access panel ( Remove the access panel).
5. Disconnect the cable.
6. Remove the tertiary riser cage.
7. Using a T-10 Torx screwdriver, remove the serial port interface.
To replace the component:To replace the component:
8. Install the serial port interface.
9. Connect the cable.
10. Install the riser.
Removing and replacing a rear serial port interface (tertiary riser) 172