5. Install the PCIe riser cage into the server.
6. Remove the shipping cap from the auxiliary cable.
7. Connect the auxiliary cable to the DSC-25 card:
a. Align the connector keying posts to the DSC-25 card.
b. Secure the auxiliary cable to the DSC-25 card using the thumbscrew.
CAUTION:CAUTION:
Do not over torque the screw.
CAUTION:CAUTION:
Do not use a screwdriver to tighten the screw.
CAUTION:CAUTION:
Do not twist the cable service loop during installation.
NOTE:NOTE:
The PCIe riser cage is not shown in this illustration for clarity purposes.
To Next Page
Loading...
