Removing and replacing a DIMMRemoving and replacing a DIMM
To identify the DIMMs installed in the server, see DIMM slot locations.
ProcedureProcedure
1. Power down the server (Power down the server).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
Extend the server from the rack ( Extend the server from the rack ).
Remove the server from the rack ( Remove the server from the rack ).
4. Remove the access panel ( Remove the access panel).
5. Do one of the following:
Remove the air baffle ( Removing the air baffle ).
Remove the 4 LFF midplane cage ( Removing and replacing a 4 LFF midplane cage ).
6. Remove the DIMM.
To replace the component, reverse the removal procedure.
For DIMM configuration information, see the server user guide.
To Next Page
Loading...
