Chapter 2
Installing the System
Setting Up the hp Integrity Superdome or hp 9000 Superdome
38
This cardboard protects the housing baffle during shipping. If it is not removed, the fans will not
work properly.
Figure 2-13Removing Protective Cardboard from the Housing
NOTE Double-check that the protective cardboard has been removed.
Step 3. Using the handles on the housing labeled Blower 3 Blower 2, part number A5201-62029, align
the edge of the housing over the edge at the top rear of the cabinet, slide it into place, and tighten
the thumbscrews at the front of the housing.
Figure 2-14Installing the Rear Blower Housing
To Next Page
Loading...
