Chapter 2
Installing the System
Setting Up the hp Integrity Superdome or hp 9000 Superdome
56
5. Repeat the above pattern until all of the cables are routed.
Step 3. Connect the Management Processor (MP) cables last.
Step 4. Reattach the cable access plate at the bottom of the cable groomer.
Step 5. Reattach the cable groomer kick plate at the back of the cabinet.
Step 6. Slip the L bracket(s) under the power cord on the rear of the PDCA.
Step 7. While holding the L bracket in place, insert the PDCA completely into the cabinet and secure the L
bracket with one screw.
To Next Page
Loading...
