Chapter 2
Installing the System
Booting and Verifying the System
71
Step 2. At the “Select Device” prompt, enter B then the cabinet number to check the power status of the
cabinet. Observe that the Power Switch: on and Power: enabled as shown in Figure 2-51.
Figure 2-51Power Status Window
Figure 2-51 shows that cells are installed in slots 0 and 4. In the cabinet, there should be cells
physically located in slots 0 and 4.
Step 3. Enter ps from the Command Menu, or if proceeding from Step 2.in the previous section, simply
press
<CR> one more time to observe the status as shown in Figure 2-52.
Figure 2-52Power Status Showing State of UGUY LEDs (and other status)
To Next Page
Loading...
