HP JG726A - Configuration Terminal Problems; No Terminal Display; Garbled Terminal Display

44
Configuration terminal problems
If the configuration environment setup is correct, the configuration terminal displays booting information
when the switch is powered on. If the setup is incorrect, the configuration terminal displays nothing or
garbled text.
No terminal display
The configuration terminal has no display when the switch is powered on.
To resolve the problem:
1. Verify that the power system is operating correctly.
2. Verify that the console cable has been connected correctly and no fault occurs on the console
cable.
3. Verify that the following settings are configured for the terminal:
{ Baud rate—9600.
{ Data bits—8.
{ Stop bits—1.
{ Parity—None.
{ Flow control—None.
4. If the problem persists, contact HP Support.
Garbled terminal display
The configuration terminal displays garbled text.
To resolve the problem:
1. Verify that the following settings are configured for the terminal:
{ Baud rate—9600.
{ Data bits—8.
{ Stop bits—1.
{ Parity—None.
{ Flow control—None.
2. If the problem persists, contact HP Support.