HP JG726A - USB Port; SFP+ Port

55
USB port
The switch has one OHC-compliant USB2.0 port that can upload and download data at a rate up to 480
Mbps. You can use this USB port to access the file system on the Flash of the switch, for example, to
upload or download application and configuration files.
NOTE:
USB devices from different manufacturers vary in compatibilities and drivers. HP does not
g
uarantee the
correct operation of all USB devices on the switch. If a USB device fails to operate on the switch, replace
it with one from another manufacturer.
SFP+ port
The LSWM124XG2Q, LSWM124XG2QL, and LSWM124XG2QFC interface modules provide SFP+
ports. You can install Gigabit SFP transceiver modules in Table 16, 1
0-Gigabit SFP+ transceiver modules
in Table 17, and 1
0-Gigabit SFP+ DAC cables in Table 18 in the SFP+ ports as needed.
IMPORTANT:
Only the SFP+ ports on the LSWM124XG2QFC interface module support the SFP-FC-8G-SW-MM850
and SFP-FC-8G-LW-SM1310 transceiver modules.
Table 16 Gigabit SFP transceiver modules available for the SFP+ ports
Product
code
HP description
Central
wavelength
(nm)
Connector
Cable/Fiber
type and
diameter
(μm)
Modal
bandwidth
(MHz × km)
Max
transmissio
n distance
JD089B
HP X120 1G SFP
RJ45 T
Transceiver
N/A RJ-45
Category-5
twisted pair
N/A
100 m
(328.08 ft)
JD118B
HP X120 1G SFP
LC SX Transceiver
850 LC
Multi-mode,
50/125
500
550 m
(1804.46 ft)
400
500 m
(1640.42 ft)
Multi-mode,
62.5/125
200
275 m
(902.23 ft)
160
220 m
(721.78 ft)
JD119B
HP X120 1G SFP
LC LX Transceiver
1310 LC
Single-mode,
9/125
N/A
10 km (6.21
miles)
Multi-mode,
50/125
500 or 400
550 m
(1804.46 ft)
Multi-mode,
62.5/125
500
550 m
(1804.46 ft)
JD061A
HP X125 1G SFP
LC LH40 1310nm
Transceiver
1310 LC
Single-mode,
9/125
N/A
40 km
(24.86 miles)