HP JG726A - Laser Safety; Installation Tools; Installation Accessories

4
• Electromagnetic wave radiation.
• Common impedance (including the grounding system) coupling.
To prevent EMI, perform the following tasks:
• If AC power is used, use a single-phase three-wire power receptacle with protection earth (PE) to
filter interference from the power grid.
• Keep the switch far away from radio transmitting stations, radar stations, and high-frequency
devices.
• Use electromagnetic shielding, for example, shielded interface cables, when necessary.
Laser safety
W
ARNING!
Do not stare into any fiber port when the switch has power. The laser li
g
ht emitted from the optical fiber
might hurt your eyes.
The switch is a Class 1 laser device.
Installation tools
No installation tools are provided with the switch. Prepare the following tools yourself:
• Phillips screwdriver.
• ESD wrist strap.
• Marker.
Installation accessories
Table 4 Installation accessories
Product code Description Quantity Applicable models
5066-0850
1 U mounting bracket kit
(including one pair of mounting
brackets and eight M4
countersunk screws)
1 kit
• HP 5930-32 QSFP+
• HP 5930-32 QSFP+ TAA
5190-0719
Mounting brackets for the HP
5930-2Slot+2QSFP+/HP
5930-2Slot+2QSFP+ TAA
1 kit
• HP 5930-2Slot+2QSFP+
• HP 5930-2Slot+2QSFP+
TAA