HP JG726A - Management Ethernet Port Leds; 1;10 Gbase-T Autosensing Ethernet Port Leds

61
Table 25 QSFP+ port LED description
LED status Description
Steady green
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 40 Gbps.
Flashing green The port is sending or receiving data at 40 Gbps.
Steady yellow
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 10 Gbps.
Flashing yellow The port is sending or receiving data at 10 Gbps.
Off No transceiver module or cable has been installed or no link is present on the port.
Management Ethernet port LEDs
The HP 5930-32 QSFP+/HP 5930-32 QSFP+ TAA and HP 5930-4Slot/HP 5930-4Slot TAA switches
provide a LINK LED and an ACT LED for the management Ethernet port.
Table 26 Management Ethernet port LED description for the HP 5930-32 QSFP+/HP 5930-32 QSFP+
TAA and HP 5930-4Slot/HP 5930-4Slot TAA switches
LED mark Status Description
LINK
Off The management Ethernet port is not connected.
Steady green The management Ethernet port is operating at 10/100/1000 Mbps.
ACT
Off The management Ethernet port is not receiving or sending data.
Flashing yellow The management Ethernet port is sending or receiving data.
The HP 5930-2Slot+2QSFP+/HP 5930-2Slot+2QSFP+ TAA switch provides a LINK/ACT LED for the
management Ethernet port.
Table 27 Management Ethernet port LED description for the HP 5930-2Slot+2QSFP+/HP
5930-2Slot+2QSFP+ TAA switch
LED mark Status Description
MGMT
LINK/ACT
Steady green The management Ethernet port is operating at 10/100/1000 Mbps.
Flashing green The management Ethernet port is receiving or sending data.
Off The management Ethernet port is not connected.
1/10GBase-T autosensing Ethernet port LEDs
Table 28 1/10GBase-T autosensing Ethernet port LED description
Status Description
Steady green The port has a link and is operating at 10 Gbps.
Flashing green The port is sending or receiving data at 10 Gbps.